Itoo Software Forum

Author Topic: Limit by Material ID not working  (Read 35392 times)

iToo

  • Administrator
  • Hero Member
  • *****
  • Posts: 4557
    • iToo Software
Limit by Material ID not working
« on: December 20, 2013, 01:28:14 PM »
Occasionally when using the Limit By Material ID option of a generator to restrict geometry to a particular section of a spine, it is generated incorrectly. This is often caused by using Adaptive mode, found in the spline’s Interpolation roll-out, which can scramble the material IDs. If this issue occurs, simply turn off adaptive mode to restore the correct behaviour.
Carlos Quintero
iToo Software