Itoo Software Forum

Author Topic: creation tools - along path problem  (Read 2013 times)

lukx

  • Full Member
  • ***
  • Posts: 167
    • lukxCGI
creation tools - along path problem
« on: April 17, 2013, 01:29:32 PM »
I wanted to create hedges along paths so I used creation tools , choosed path and the problme is that some geometry is flying and not on the path :
What might be causing this?

iToo

  • Administrator
  • Hero Member
  • *****
  • Posts: 4388
    • iToo Software
Re: creation tools - along path problem
« Reply #1 on: April 17, 2013, 04:27:39 PM »

Is there a surface assigned ? If so, please check if Surface->Custom Edit Mode->Link to Surface is On.

Carlos Quintero
iToo Software

lukx

  • Full Member
  • ***
  • Posts: 167
    • lukxCGI
Re: creation tools - along path problem
« Reply #2 on: April 17, 2013, 05:09:39 PM »
Thank you Carlos. when turning off link to surface helped :) And also UV mode helped :)