Itoo Software Forum

Forest Pack => Forest Pro (*) => Topic started by: lukx on April 17, 2013, 01:29:32 PM

Title: creation tools - along path problem
Post by: lukx on April 17, 2013, 01:29:32 PM
I wanted to create hedges along paths so I used creation tools , choosed path and the problme is that some geometry is flying and not on the path : (http://clip2net.com/clip/m15854/1366198060-clip-61kb.jpg)
What might be causing this?
Title: Re: creation tools - along path problem
Post by: iToo on April 17, 2013, 04:27:39 PM

Is there a surface assigned ? If so, please check if Surface->Custom Edit Mode->Link to Surface is On.

Title: Re: creation tools - along path problem
Post by: lukx on April 17, 2013, 05:09:39 PM
Thank you Carlos. when turning off link to surface helped :) And also UV mode helped :)