Itoo Software Forum

Author Topic: Distribution Reference Mode  (Read 2160 times)

Klonsemann

  • Jr. Member
  • **
  • Posts: 61
Distribution Reference Mode
« on: March 06, 2020, 10:44:11 AM »
When generating trees at pivot position from multiple splines that come from architectures plans.
Is there a way to tell FP to use a specific geometry ID (other than 1) ?

Spline-MaterialIDs or ObjectIDs seem not to work.

We currently switch to "Custom Edit Mode" to set a different ID from the geometry list.
We also know the trees interface and setGeomID, but we want to avoid to switch to "Custom Edit Mode"

Michal Karmazín

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2447
Re: Distribution Reference Mode
« Reply #1 on: March 09, 2020, 10:39:56 AM »
Hi,

Sure, even when working in the Generate mode, you can "Select models" for each Area - in the Select models window, you can Pick the desired item(s).

Best regards,