Itoo Software Forum

Author Topic: Exclude splines - don't see islands?  (Read 2284 times)

CQ1841

  • Newbie
  • *
  • Posts: 10
Exclude splines - don't see islands?
« on: January 15, 2010, 06:42:36 AM »
Hopefully, this diagram shows what i'm talking about. Of course I could just combine the two and trim, but using an exclude spline is so much quicker and better workflow!


iToo

  • Administrator
  • Hero Member
  • *****
  • Posts: 3158
    • iToo Software
Re: Exclude splines - don't see islands?
« Reply #1 on: January 15, 2010, 06:35:01 PM »

You are right, the result is not geometrically correct. The problem is we are processing the raw splines, but not their hierarchy.

If there are not problems, i think we can fix this issue for the next patch.

Carlos Quintero
iToo Software