Itoo Software Forum
Forest Pack => Forest Pro (*) => Topic started by: leonardo.afanador on December 20, 2018, 03:06:11 PM
-
hi,
I`m creating a forest simulating leaves on the border of the road, controlled with falloff and inverted curve, so far so good, as in screenshot 1 (see attached); but when I put on top of these an additional paint area to exclude even more leaves, it`s not working as expected; the paint area exclude the leaves, but around the exluded area mores leaves appeared (see attached 2).
How is the correct workflow to do this?
thank you
-
Hi
we need to see Your setup to give a personalized solution.
Works fine with this setup:
(https://i.imgur.com/ACMTYjB.png)