Itoo Software Forum

Author Topic: feature request - UVW mode - limit ID  (Read 974 times)

BL_zoomvp

  • Newbie
  • *
  • Posts: 26
feature request - UVW mode - limit ID
« on: September 12, 2016, 03:44:41 PM »
Hi there.

Using Areas in a forest is outstanding great.  :)

Would it be possible to add some of the area features for UVW scattering mode?
I can imagine that implementing splines/paint with exclude or include is not that easy.

But what about the features:
- limit to surface id
and
- select models

These two in combination are very powerful.  ;)
It would be a great benefit when using UVW-mode.

Best regards

iToo

  • Administrator
  • Hero Member
  • *****
  • Posts: 4388
    • iToo Software
Re: feature request - UVW mode - limit ID
« Reply #1 on: September 12, 2016, 04:42:30 PM »
Hi, unfortunately these features would require at least a partial support of Areas in UV mode. But that is a bit tricky, because most of Area functions are written for XY.
Anyway we want to improve UV mode since some time ago, but we were busy with other features. I hope it can be done in next releases.

I take note of your suggestion. Thanks for that.
Carlos Quintero
iToo Software

BL_zoomvp

  • Newbie
  • *
  • Posts: 26
Re: feature request - UVW mode - limit ID
« Reply #2 on: September 12, 2016, 06:07:38 PM »
Thank you for the reply.  :)