Itoo Software Forum

Forest Pack => Forest Pro (*) => Topic started by: BL_zoomvp on September 12, 2016, 03:44:41 PM

Title: feature request - UVW mode - limit ID
Post by: BL_zoomvp on September 12, 2016, 03:44:41 PM
Hi there.

Using Areas in a forest is outstanding great.  :)

Would it be possible to add some of the area features for UVW scattering mode?
I can imagine that implementing splines/paint with exclude or include is not that easy.

But what about the features:
- limit to surface id
and
- select models

These two in combination are very powerful.  ;)
It would be a great benefit when using UVW-mode.

Best regards
Title: Re: feature request - UVW mode - limit ID
Post by: iToo on September 12, 2016, 04:42:30 PM
Hi, unfortunately these features would require at least a partial support of Areas in UV mode. But that is a bit tricky, because most of Area functions are written for XY.
Anyway we want to improve UV mode since some time ago, but we were busy with other features. I hope it can be done in next releases.

I take note of your suggestion. Thanks for that.
Title: Re: feature request - UVW mode - limit ID
Post by: BL_zoomvp on September 12, 2016, 06:07:38 PM
Thank you for the reply.  :)