ITOOSOFT Forum

Author Topic: Forest Pack & Balcony Plants  (Read 77 times)

KD4391

  • Jr. Member
  • **
  • Posts: 59
Forest Pack & Balcony Plants
« on: July 13, 2025, 01:46:16 pm »
Hi team

What is the best method/practice to use forest pack when the plans to be distributed, are on top of each other on different levels - see attached.
What i am currently doing, is detaching each surface for each balcony as its own mesh and then adding all these meshes individually within the surfaces rollout - is this the best way to do it?  it feels a bit clumsy

Michal Karmazín

  • ITOOSOFT
  • Hero Member
  • *****
  • Posts: 3042
Re: Forest Pack & Balcony Plants
« Reply #1 on: Today at 10:27:34 am »
Hi,

Even if you prefer using Surface Area over Spline Area(s), which is often more flexible, there’s still no need to detach them. Instead, you can use the UV mode and adjust the UV mapping slightly for each level to differentiate them. I hope this helps.

Best regards,