Itoo Software Forum

Author Topic: Groups + collisions = mayhem!  (Read 498 times)

JamesB

  • Newbie
  • *
  • Posts: 6
Groups + collisions = mayhem!
« on: November 08, 2022, 03:51:09 PM »
Sorry if this has been posted already. I am trying to create an office layout using groups of proxies, and adding these groups to the geometry rollout. So far so good, it works fine. However if I enable collisions, it appears to completely breaks the groups' heirachies.

Attachment 1 shows how it looks with collisions switched off. Each rectangle you can see is a referencing a group of proxies.
Attachment 2 shows what happens when I enable collisions.

Michal Karmazín

  • iToo Software
  • Hero Member
  • *****
  • Posts: 1914
Re: Groups + collisions = mayhem!
« Reply #1 on: November 09, 2022, 09:06:52 AM »
Hi,

I’m afraid, that the Collisions feature doesn’t support Groups at the moment. We'll see what can be done in future versions.

Best regards,