Itoo Software Forum

Author Topic: Hedge Preset Widths  (Read 984 times)

iCreateLtd

  • Jr. Member
  • **
  • Posts: 95
Hedge Preset Widths
« on: September 25, 2021, 01:35:59 PM »
Hi all.

Is there a way to control the width of FP's hedge presets?

We use a method where RC is assigned to a curve & FP is assigned to the RC.  And we've added parameters to control the width and height of the RC.

Is there any way we can do this with the hedges presets?

Thanks,

Sean

Paul Roberts

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2991
Re: Hedge Preset Widths
« Reply #1 on: September 27, 2021, 04:00:33 PM »
Hi Sean,

The hedge presets are created by distributing pre-built models so I'm afraid there's not a way to control them parametrically. You can always scale the source geometry, but that's probably not what you're looking for.

Paul
Paul Roberts
iToo Software