Itoo Software Forum

« previous next »
Pages: [1]

Author Topic: Hedge Preset Widths  (Read 39077 times)

iCreateLtd

  • Full Member
  • ***
  • Posts: 107
Hedge Preset Widths
« on: September 25, 2021, 01:35:59 PM »
Hi all.

Is there a way to control the width of FP's hedge presets?

We use a method where RC is assigned to a curve & FP is assigned to the RC.  And we've added parameters to control the width and height of the RC.

Is there any way we can do this with the hedges presets?

Thanks,

Sean
Logged

Paul Roberts

  • iToo Software
  • Hero Member
  • *****
  • Posts: 3059
Re: Hedge Preset Widths
« Reply #1 on: September 27, 2021, 04:00:33 PM »
Hi Sean,

The hedge presets are created by distributing pre-built models so I'm afraid there's not a way to control them parametrically. You can always scale the source geometry, but that's probably not what you're looking for.

Paul
Logged
Paul Roberts
iToo Software
Pages: [1]
« previous next »