Itoo Software Forum
Forest Pack => Forest Pro (*) => Topic started by: iCreateLtd on September 25, 2021, 01:35:59 PM
-
Hi all.
Is there a way to control the width of FP's hedge presets?
We use a method where RC is assigned to a curve & FP is assigned to the RC. And we've added parameters to control the width and height of the RC.
Is there any way we can do this with the hedges presets?
Thanks,
Sean
-
Hi Sean,
The hedge presets are created by distributing pre-built models so I'm afraid there's not a way to control them parametrically. You can always scale the source geometry, but that's probably not what you're looking for.
Paul