Itoo Software Forum

Author Topic: MAT IDs together with REFERENCE geometry in FP  (Read 65 times)

Dragan

  • Jr. Member
  • **
  • Posts: 92
MAT IDs together with REFERENCE geometry in FP
« on: October 27, 2018, 10:34:29 AM »
Hi,
It would be good if there was an option to choose MAT IDs  together with REFERENCE geometry in FP.

1. RC generated model with various geometry but also with `Reference Triangle/dummy` included witch have specific MAT ID.
2. FP distribution mode set to REFERENCE + MAT ID to match RC reference  (could be multiple numbers for filter)

e.g. RC generated car parking lines with TRIANGLES as Reference for FP to distribute cars between lines. (RC also can do the job for randomly rotating and shifting cars/empty places etc.)
I already use this approach to distribute cars and it works great. RC do the job for rotating/shifting etc. and even adding handicapped section via different spline ID.
Only issue is that I need to create two RC object, one for parking lines and other just for reference.
 
With Option for `filter` by MAT ID  in FP Reference mode we could use complex geometry as a Reference.

Hope it make any sense...
Best Regards
Dragan
 
 
« Last Edit: October 27, 2018, 10:51:07 AM by Dragan »

Rokas

  • iToo Software
  • Hero Member
  • *****
  • Posts: 1166
    • iToo
Re: MAT IDs together with REFERENCE geometry in FP
« Reply #1 on: October 27, 2018, 01:33:34 PM »
It does makes sense. Added to improvements list.
« Last Edit: October 27, 2018, 01:36:03 PM by Rokas »
Rokas
iToo Software