Itoo Software Forum

Author Topic: New ivy generator  (Read 9645 times)

Crayox

  • Jr. Member
  • **
  • Posts: 86
New ivy generator
« on: September 12, 2024, 11:57:34 AM »
Hi guys,
seen it demonstrated. Is there a way to get the beta and try it out? Or any info when it'll be released?
Thx!

Michal Karmazín

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2779
Re: New ivy generator
« Reply #1 on: September 12, 2024, 12:04:49 PM »
Hi,

Of course, feel free to give it a try. It can be downloaded from the User Panel in the Downloads - Beta versions section.

Best regards,

Crayox

  • Jr. Member
  • **
  • Posts: 86
Re: New ivy generator
« Reply #2 on: September 12, 2024, 12:05:59 PM »
Sweet!!! Thanks

Crayox

  • Jr. Member
  • **
  • Posts: 86
Re: New ivy generator
« Reply #3 on: September 16, 2024, 12:15:14 PM »
Hi,

Of course, feel free to give it a try. It can be downloaded from the User Panel in the Downloads - Beta versions section.

Best regards,

There's strange behavior when an object is bellow 0 on z axis, so I built the ivy above but now I can't move it back down. Can't use instantiate yet, right? Nor turn it into editable poly after building.

Crayox

  • Jr. Member
  • **
  • Posts: 86
Re: New ivy generator
« Reply #4 on: September 16, 2024, 01:47:54 PM »
Seems ok if I create it and then move both the generator and object down at the same time :)

Crayox

  • Jr. Member
  • **
  • Posts: 86
Re: New ivy generator
« Reply #5 on: September 26, 2024, 02:19:26 PM »
Thanks for the new Ivy guys! I love the library in the official release! Just one thing, the bug still remains. If the object is bellow 0 on z-axis and you start creating on negative z values strange behavior occurs where it seems ivy is casting branches to the ground level.

iToo

  • Administrator
  • Hero Member
  • *****
  • Posts: 4593
    • iToo Software
Re: New ivy generator
« Reply #6 on: September 27, 2024, 08:57:25 AM »
Thanks for the new Ivy guys! I love the library in the official release! Just one thing, the bug still remains. If the object is bellow 0 on z-axis and you start creating on negative z values strange behavior occurs where it seems ivy is casting branches to the ground level.

Hi, Unfortunately it was not possible to check this issue for the stable release, but we'll check it for next update.

Carlos Quintero
iToo Software

Crayox

  • Jr. Member
  • **
  • Posts: 86
Re: New ivy generator
« Reply #7 on: September 27, 2024, 01:38:38 PM »
Of course, no prob. Just that it is reported.

QR1757

  • Newbie
  • *
  • Posts: 8
Re: New ivy generator
« Reply #8 on: September 29, 2024, 02:39:00 AM »
The Ivy Library doesn't even work.