Itoo Software Forum

Author Topic: Help with distribution on a complex surface  (Read 1490 times)

OU9561

  • Jr. Member
  • **
  • Posts: 60
Help with distribution on a complex surface
« on: February 10, 2022, 10:17:26 PM »
Hi everyone!
I'm doing this rock distribution on a complex surface that was generated on a different software.

The problem I'm having is that if I set it to XY UV Tranform, it doesn't work, and if I set it to UV I get this result where the distribution is more dense on the top and very sparse on the bottom.
I'm really not that familiar with Unwrap UVW so I don't know how to make it more evenly distributed, does any one have any tips or pointers?

thank you!

Paul Roberts

  • iToo Software
  • Hero Member
  • *****
  • Posts: 3054
Re: Help with distribution on a complex surface
« Reply #1 on: February 11, 2022, 10:49:36 AM »
To fix this I would try the following

- Add a Unwrap UVW modifier
- Open the UV Editor
- Switch to face mode and press Ctrl + A to select them all
- Press the planar mapping butting. This'll create a basic UVW map and remove any unwanted seams
- Press the Quick Peel button to relax the map and regularise the UVW distribution.



I hope that helps.
Paul
Paul Roberts
iToo Software

OU9561

  • Jr. Member
  • **
  • Posts: 60
Re: Help with distribution on a complex surface
« Reply #2 on: February 11, 2022, 02:39:14 PM »
To fix this I would try the following

- Add a Unwrap UVW modifier
- Open the UV Editor
- Switch to face mode and press Ctrl + A to select them all
- Press the planar mapping butting. This'll create a basic UVW map and remove any unwanted seams
- Press the Quick Peel button to relax the map and regularise the UVW distribution.



I hope that helps.
Paul

That's perfect Paul, thank you very much!