Itoo Software Forum

Author Topic: Problem with mesh view  (Read 5958 times)

Lintang

  • Newbie
  • *
  • Posts: 2
Problem with mesh view
« on: June 10, 2012, 01:19:41 PM »
hello,

i use 3dsmax 2012 and HQ Catalog 1.0

when I use the HQ plants by selecting the library, I found a problem when the mesh view, the tree is gone (nothing), and only letter ' F ' in the floor, and, when i render, i found error again, help me!

iToo

  • Administrator
  • Hero Member
  • *****
  • Posts: 4388
    • iToo Software
Re: Problem with mesh view
« Reply #1 on: June 10, 2012, 01:26:45 PM »

Please, click "General->Forest Stats", to open the information window, and see what it is the problem exactly.

Carlos Quintero
iToo Software

Lintang

  • Newbie
  • *
  • Posts: 2
Re: Problem with mesh view
« Reply #2 on: June 10, 2012, 03:50:18 PM »
the problem is

"Maximum number of faces exceeded
fix : adjust "Display" parameters"

i'm sory what that mean ?

iToo

  • Administrator
  • Hero Member
  • *****
  • Posts: 4388
    • iToo Software
Re: Problem with mesh view
« Reply #3 on: June 10, 2012, 04:19:09 PM »

Probably you are using the scanline renderer. This render engine is very limited to handle high-poly objects (as the HQ Plant models), because it creates a single mesh with all the plants.  You should use Mental Ray or VRay.

In this is not the case, please check if Display->Render Mode is set to "Automatic".

Carlos Quintero
iToo Software