I would like to know if you could add a new checkbox in Spline Offset to create knots on the original spline's interpolated curve points. I would like to have the results where the extra sub-splines always have knots that line up with ones in the original spline. Right now, if you use a shape that's using interpolation, the results will look correct but the amount of knots in the added subsplines does not match those in the source spline.

Now that I think about it, there should be two optional methods for the knots/interpolation:

or

See attached image where the highlighted spline (in red) is the original Circle shape. Notice that the internal subsplines added by spline offset has a different knot count from the source. I want to be able to keep them consistent by choosing the options above.

Now that I think about it, there should be two optional methods for the knots/interpolation:

**Option 1:**Insert Knots into Original Spline at interpolated knot pointsor

**Option 2:**Match knot count and interpolation of added sub splines to original.See attached image where the highlighted spline (in red) is the original Circle shape. Notice that the internal subsplines added by spline offset has a different knot count from the source. I want to be able to keep them consistent by choosing the options above.