Itoo Software Forum

« previous next »
Pages: [1]

Author Topic: Basic Parquet not working.  (Read 9227 times)

LM1206

  • Newbie
  • *
  • Posts: 34
Basic Parquet not working.
« on: May 05, 2019, 02:16:29 AM »
I'm following the parquet tutorial at https://www.itoosoft.com/tutorials/parquet-floor
I've attached the file.
This is not working as in the tutorial. Does the sequence component not work the same way anymore?
Logged

LM1206

  • Newbie
  • *
  • Posts: 34
Re: Basic Parquet not working.
« Reply #1 on: May 05, 2019, 02:49:57 AM »
I've attached a file that gets a little further using translation and padding, but can't finish. That's two for two with this plugin trial
Logged

LM1206

  • Newbie
  • *
  • Posts: 34
Re: Basic Parquet not working.
« Reply #2 on: May 05, 2019, 02:58:38 AM »
Scaling objects in the tutorial keeps them side by side flush to each other. Doing so in the plugin creates gaps....wtf? Again is this just an outdated tutorial =?
Logged

Rokas

  • Hero Member
  • *****
  • Posts: 3324
Re: Basic Parquet not working.
« Reply #3 on: May 06, 2019, 02:07:51 PM »
Hi. Tutorial is still fine. Sequence is working as expected.
You did not mark Increment on "Y" Mode . And Your segments are rotated in 90 degrees:
Logged
Rokas

LM1206

  • Newbie
  • *
  • Posts: 34
Re: Basic Parquet not working.
« Reply #4 on: May 06, 2019, 05:02:30 PM »
thanks , kept hitting that button, but it never worked... didn't think to rotate the object along with this. Thanks again.
Logged
Pages: [1]
« previous next »