RailClone > RailClone Lite
Corners on linear array
RG1597:
Can someone save me a lot of time and tell me if this is at least possible? It's been a while since I used railclone and I'm out of step with the basics.
I have 3 different sized facade panels, I want to send them round a spline. Can I adaptively scale them to fit as whole objects in to the corners? My spline has a few sections of very different lengths by the way. I don't want to use a separate corner segment if possible, and I'm up to the max 3 segments anyway..
RG1597:
I've realised that it works as expected on addaptive with the segment plugged straight in to the array, but the randomize node screws it up. Is this a limitation of the software?
Dragan:
For adaptive mode to work properly all segments should be the same on the X size. So, you could pre-prepare some combinations of window sets to be the same on X size since you are limited to the 3 segments in RC Lite.
RG1597:
Thanks, unfortunately, visually, that doesn't have the same effect as the three seperate elements. Is there a better way to to do this with RC pro?
Dragan:
RC Pro is a whole new `game-level`. Not just on software capabilities but Itoo support is great. Most of the time you will get a complete solution for your problem and not just some guidelines as you get with some others.
Navigation
[0] Message Index
[#] Next page
Go to full version