Itoo Software Forum

Author Topic: Metal Gate  (Read 6638 times)


  • Newbie
  • *
  • Posts: 11
Metal Gate
« on: January 18, 2016, 06:19:02 PM »
I am trying to make a fence with metal gate, but I got lost in the controls :p
I though in doing everything in one system but since I failed I am separating in two.
For the gate I am struggling, using the command mirror and condition, I can do the horizontals, top and bottom to cut right in the middle of the spline (were the gates open) but the poles  I can not make them to place in the middle of the spline.
I looked on the samples from rail clone fences but the system are very complex I am hoping to find a easy way to do it, or if there is no way, well so be it ;)
I am using rail clone pro, but I don't have access to the pro Forum because IT hold the license.
Thank you.


  • Administrator
  • Hero Member
  • *****
  • Posts: 4327
    • iToo Software
Re: Metal Gate
« Reply #1 on: January 19, 2016, 08:44:24 AM »
Hi, i'm afraid we cannot provide technical support in the Lite forum.
Please, send us your RC license info to, and we'll enable your account for the Pro forum.

Carlos Quintero
iToo Software