RailClone > RailClone Lite

Decorative tile pattern

(1/2) > >>

anthonyhartleydenton:
Hi All

new to the forum and was wondering if anyone might be able to help.  I am using Railclone preset.  the pattern and colour are perfect but I need to get the half-moon feature tiles to run in a 3, not a 2 and only in the location on the drawing. 

Could anyone point me in the direction of the parameters I should be looking at?

thanks, Tony

Michal Karmazín:
Hi Tony,

The easiest way would probably be to use two Clipping Areas (to use these "decorative tiles" just at the specified location) - either within two individual RC objects or within two Generators within one RC object. You can adjust the number of "decorative tiles" by setting the "Decorative Tile Y Count" parameter. I hope that helps.

Best regards,

anthonyhartleydenton:
is there not a way to do it by modifying the settings of the template already in the library?  I have it applied to all the buildings already so it would be easier. creating separate clipping areas across multiple facades and 14 buildings will be time-consuming.  thanks T

Michal Karmazín:
Well, if "decorative tiles" should always be placed at the same height, you can try raising the "Standard Tile Y Count" value (which drives the counter in the Sequence Operator) until it fits your needs.

Best regards,

anthonyhartleydenton:
Hi Michal thanks for the help.  so I've got the following and two queries if you might be able to help.

1. how to i get 3 rows of tiles?
2. how do i shunt the 3 rows downward to align where shown.  If tried changing the y count up when the numbers gets too small more decorative tiles keep appearing top and bottom.

thanks again  T

Navigation

[0] Message Index

[#] Next page