Itoo Software Forum

Author Topic: itoo lite csn make the geometry follllow the nside of a spline rather the outsid  (Read 6458 times)

512Pixel

  • Newbie
  • *
  • Posts: 2
I have create a spline and then used the following tools in itoo to create the geometry .please  see attachment  MY issue  i would like the path to made on the inside of the spline . the geometry is curtrently on the outside of the spline over laps the road

Michal Karmazín

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2447
Hi,

Setting the General - Alignment - Y: Bottom for used Segment (or using the Pivot option and adjusting the Pivot Point accordingly) should do the trick. Hope that helps.

Best regadrs,