Itoo Software Forum
RailClone => RailClone Lite => Topic started by: 512Pixel on January 03, 2017, 10:03:54 AM
-
I have create a spline and then used the following tools in itoo to create the geometry .please see attachment MY issue i would like the path to made on the inside of the spline . the geometry is curtrently on the outside of the spline over laps the road
-
Hi,
Setting the General - Alignment - Y: Bottom for used Segment (or using the Pivot option and adjusting the Pivot Point accordingly) should do the trick. Hope that helps.
Best regadrs,