Itoo Software Forum

Author Topic: Metal Gate  (Read 6951 times)

Fco3d

  • Newbie
  • *
  • Posts: 11
Metal Gate
« on: January 18, 2016, 06:19:02 PM »
Hello,
I am trying to make a fence with metal gate, but I got lost in the controls :p
I though in doing everything in one system but since I failed I am separating in two.
For the gate I am struggling, using the command mirror and condition, I can do the horizontals, top and bottom to cut right in the middle of the spline (were the gates open) but the poles  I can not make them to place in the middle of the spline.
I looked on the samples from rail clone fences but the system are very complex I am hoping to find a easy way to do it, or if there is no way, well so be it ;)
I am using rail clone pro, but I don't have access to the pro Forum because IT hold the license.
Thank you.

iToo

  • Administrator
  • Hero Member
  • *****
  • Posts: 4388
    • iToo Software
Re: Metal Gate
« Reply #1 on: January 19, 2016, 08:44:24 AM »
Hi, i'm afraid we cannot provide technical support in the Lite forum.
Please, send us your RC license info to helpdesk@itoosoft.com, and we'll enable your account for the Pro forum.

Thanks,
Carlos Quintero
iToo Software