Itoo Software Forum

RailClone => RailClone Lite => Topic started by: Fco3d on January 18, 2016, 06:19:02 PM

Title: Metal Gate
Post by: Fco3d on January 18, 2016, 06:19:02 PM
Hello,
I am trying to make a fence with metal gate, but I got lost in the controls :p
I though in doing everything in one system but since I failed I am separating in two.
For the gate I am struggling, using the command mirror and condition, I can do the horizontals, top and bottom to cut right in the middle of the spline (were the gates open) but the poles  I can not make them to place in the middle of the spline.
I looked on the samples from rail clone fences but the system are very complex I am hoping to find a easy way to do it, or if there is no way, well so be it ;)
I am using rail clone pro, but I don't have access to the pro Forum because IT hold the license.
Thank you.
Title: Re: Metal Gate
Post by: iToo on January 19, 2016, 08:44:24 AM
Hi, i'm afraid we cannot provide technical support in the Lite forum.
Please, send us your RC license info to helpdesk@itoosoft.com, and we'll enable your account for the Pro forum.

Thanks,