Itoo Software Forum

Author Topic: need a tip for T and l Junction.  (Read 1315 times)

adnanmalik23

  • Newbie
  • *
  • Posts: 19
need a tip for T and l Junction.
« on: July 20, 2014, 02:25:40 PM »
is there any manual way to make T and L junction for road and highway using railcone. i know it's not possible using a single spline but how we do it. i have a lot of problem in editing the railclone mesh manually.

iToo

  • Administrator
  • Hero Member
  • *****
  • Posts: 3076
    • iToo Software
Re: need a tip for T and l Junction.
« Reply #1 on: July 20, 2014, 06:53:42 PM »
Really there is not a procedure to creation junctions, since RailClone doesn't support them.
You would place a T segment in some point of a linear generator, and then align visually the geometry (i.e. moving the spline of other RC generator) to match the junction's end.
Carlos Quintero
iToo Software

adnanmalik23

  • Newbie
  • *
  • Posts: 19
Re: need a tip for T and l Junction.
« Reply #2 on: July 21, 2014, 02:22:56 AM »
now take a look at the image i making a same thing thing. guide me by capturing ur image.

iToo

  • Administrator
  • Hero Member
  • *****
  • Posts: 3076
    • iToo Software
Re: need a tip for T and l Junction.
« Reply #3 on: July 21, 2014, 09:04:06 AM »
Sorry, but this type of questions goes beyond our support policy for Lite products. Please, see the rules here.
Carlos Quintero
iToo Software