Itoo Software Forum

RailClone => RailClone Lite => Topic started by: adnanmalik23 on July 20, 2014, 02:25:40 PM

Title: need a tip for T and l Junction.
Post by: adnanmalik23 on July 20, 2014, 02:25:40 PM

is there any manual way to make T and L junction for road and highway using railcone. i know it's not possible using a single spline but how we do it. i have a lot of problem in editing the railclone mesh manually.

Title: Re: need a tip for T and l Junction.
Post by: iToo on July 20, 2014, 06:53:42 PM

Really there is not a procedure to creation junctions, since RailClone doesn't support them.
You would place a T segment in some point of a linear generator, and then align visually the geometry (i.e. moving the spline of other RC generator) to match the junction's end.

Title: Re: need a tip for T and l Junction.
Post by: adnanmalik23 on July 21, 2014, 02:22:56 AM

now take a look at the image i making a same thing thing. guide me by capturing ur image.

Title: Re: need a tip for T and l Junction.
Post by: iToo on July 21, 2014, 09:04:06 AM

Sorry, but this type of questions goes beyond our support policy for Lite products. Please, see the rules (http://forum.itoosoft.com/index.php?topic=2011.0) here.