RailClone > RailClone Lite
need a tip for T and l Junction.
(1/1)
adnanmalik23:
is there any manual way to make T and L junction for road and highway using railcone. i know it's not possible using a single spline but how we do it. i have a lot of problem in editing the railclone mesh manually.
iToo:
Really there is not a procedure to creation junctions, since RailClone doesn't support them.
You would place a T segment in some point of a linear generator, and then align visually the geometry (i.e. moving the spline of other RC generator) to match the junction's end.
adnanmalik23:
now take a look at the image i making a same thing thing. guide me by capturing ur image.
iToo:
Sorry, but this type of questions goes beyond our support policy for Lite products. Please, see the rules here.
Navigation
[0] Message Index
Go to full version