Itoo Software Forum

RailClone => RailClone Pro (*) => Topic started by: Macker on November 15, 2019, 12:44:07 PM

Title: "evenly" piece not displaying
Post by: Macker on November 15, 2019, 12:44:07 PM

Hi all,

I've got an issue with some glazing I'm making. I't s a pretty simple setup, but I've got an issue where it isn't placing an "x evenly" piece where it ought to, perhaps because it's too close to the bezier corner where the curve begins.

I can rectify this by adding the "evenly" geometry to the "corner" input, however this then gives me a piece of geometry elsewhere where I don't need it. I'm a little perplexed as to how to rectify this. I've attached a screenshot that hopefully helps you understand what I'm talking about.

Title: Re: "evenly" piece not displaying
Post by: Michal Karmazín on November 15, 2019, 02:42:34 PM

Hi,

As it's really hard to say just from provided screen-shot what might be causing it, would you mind to send us your scene to check it here? Thanks in advance.

Best regards,

Title: Re: "evenly" piece not displaying
Post by: Macker on November 15, 2019, 03:56:53 PM

Hi Michal,

Sure; see attached.

Title: Re: "evenly" piece not displaying
Post by: Michal Karmazín on November 18, 2019, 11:04:11 AM

Hi,

Setting the Rules > Corner > Bevel Mode to None of the "Velfac Windows" Generator seems to fix it. Please find attached the modified scene. I hope that helps.

Best regards,

Title: Re: "evenly" piece not displaying
Post by: Macker on November 19, 2019, 01:24:21 PM

Perfect, thank you!