Yes, In reality, there would be cuts, sometimes, but in this case, even if there are going to be cuts, there should still only be a brick and a half brick. Now, I have an 8" brick, a 6.3545" brick, and a 9.2454" brick in the same course.
The spline in this case will be adjusted as needed, but each brick should not be cut or stretched, even if the end bricks go beyond the spline.
Can this be achieved? Sorry if I've not been clear.
Like attached...you see, only one size brick. The smaller bricks at corner are just the ends of full sized bricks.
This is all I am trying to accomplish
nothing special, literally standard masonry
Running Bond.
Thanks again for all your efforts!