Itoo Software Forum

Author Topic: Nested RailClones  (Read 3870 times)

4+Arquitectos, Lda

  • Newbie
  • *
  • Posts: 25
Nested RailClones
« on: April 16, 2014, 12:42:15 PM »
Don't know if it's already on the wish list, but using a railclone array output as a segment, all inside the editor.

Best regards,


  • Jr. Member
  • **
  • Posts: 54
    • JG
Re: Nested RailClones
« Reply #1 on: April 16, 2014, 01:13:04 PM »
I just tried that before... with my problemati curved patterned facade...

It seems to work if you add a previous RC-Object as an segment into a new RC-object. Still its a Sollution with 2 RC Object instead all in one...


  • Administrator
  • Hero Member
  • *****
  • Posts: 4001
    • iToo Software
Re: Nested RailClones
« Reply #2 on: April 16, 2014, 02:33:40 PM »
Yes, you can assign a RailClone object as a segment. In fact, there are specific options for nested objects as Segment->Deform->Nest.

The only drawback is that the inner object is handled as a mesh by the instancing engine (their individual segments cannot be instanced). In some cases, this may be less efficient that using an array (where each piece can be instanced).
Carlos Quintero
iToo Software