RailClone > RailClone Pro (*)
Adeka Cladding
LC3D:
I'm having trouble getting this one to work?
I've created 2 A2S arrays and am trying to offset them with the padding... is there a better or easier way as I just cannot get it to line up - the values seem to move in unpredictable increments...
any help would be greatly appreciated.
Paul Roberts:
Please take a look at the attached file. To get the alternating rows I'm using a half segment and a full segment in the Start and End input. To overlap the tiles a simple negative top padding value seems to do the trick.
Cheers,
Paul
LC3D:
--- Quote from: Paul Roberts on May 13, 2022, 03:42:24 PM ---Please take a look at the attached file. To get the alternating rows I'm using a half segment and a full segment in the Start and End input. To overlap the tiles a simple negative top padding value seems to do the trick.
Cheers,
Paul
--- End quote ---
you Sir, are a legend. Thank you very very much!
LC3D:
--- Quote from: Paul Roberts on May 13, 2022, 03:42:24 PM ---Please take a look at the attached file. To get the alternating rows I'm using a half segment and a full segment in the Start and End input. To overlap the tiles a simple negative top padding value seems to do the trick.
Cheers,
Paul
--- End quote ---
Hey Paul,
any idea why when i attach a much larger spline or modify the spline from your scene to be much larger it doesn't work, just says "no geometry"... I've increased the segments and Faces Limits...?
Paul Roberts:
Hi!
How large do you need to go? I just tried a spline that was 100m x 100m and it seemed to work fine here.
Cheers,
Paul
Navigation
[0] Message Index
[#] Next page
Go to full version