Itoo Software Forum

RailClone => RailClone Pro (*) => Topic started by: lukx on January 06, 2016, 12:56:55 PM

Title: again rounded corner problem
Post by: lukx on January 06, 2016, 12:56:55 PM

sorry guys to bother you again but again I have problem with rounded corner :(
simple curb form your styles: (http://c2n.me/3sAZGrm.png)


https://www.dropbox.com/s/an2ir9ihu3s23k9/curb.max?dl=0

Title: Re: again rounded corner problem
Post by: Paul Roberts on January 06, 2016, 01:40:26 PM

Hi,

Unfortunately this is caused by a known limitation when using the Generator > Limit to ID feature on curved splines. Internally each spline section is considered separate so it cannot compute the curves required to create a continuous deformation where the two IDs adjoin. The simplest solution therefore is to add a couple of extra vertices either side of the curved section so that the change starts on a straight section of the pavement. I've attached your file with that change applied.

If this isn't possible there is a workaround that uses Conditional nodes instead of the Limit by ID feature. You can read more about this and download a sample file in this post (http://forum.itoosoft.com/index.php?topic=3109.msg12020#msg12020).

I hope that helps.

Many thanks!

Paul.