Itoo Software Forum

Author Topic: align joints  (Read 1352 times)

lebonmarie

  • Newbie
  • *
  • Posts: 32
align joints
« on: March 07, 2016, 07:47:36 PM »
hello

will I like to align the joints of the glazing
I will also like to put posts at the angles, but when I put those, they are not fixed well  :-\
How then I to make that ?
Thanks a lot


http://we.tl/jadtzPyahv

Michal Karmazín

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2447
Re: align joints
« Reply #1 on: March 08, 2016, 01:29:47 PM »
Hi,

I would suggest you to check following "Facade panels have to stay vertical at same position?" tightly related thread.

Using the Adaptive mode and wiring an empty Segment into the Corner slot will "break" the Array on any vertex, which should help for such scenario.

Hope you'll find it useful.

Best regards,

lebonmarie

  • Newbie
  • *
  • Posts: 32
Re: align joints
« Reply #2 on: March 11, 2016, 04:55:09 PM »
Thanks to much !!!!!!  ;D