Itoo Software Forum

RailClone => RailClone Pro (*) => Topic started by: lebonmarie on March 07, 2016, 07:47:36 PM

Title: align joints
Post by: lebonmarie on March 07, 2016, 07:47:36 PM
hello

will I like to align the joints of the glazing
I will also like to put posts at the angles, but when I put those, they are not fixed well  :-\
How then I to make that ?
Thanks a lot


http://we.tl/jadtzPyahv
Title: Re: align joints
Post by: Michal KarmazĂ­n on March 08, 2016, 01:29:47 PM
Hi,

I would suggest you to check following "Facade panels have to stay vertical at same position? (http://forum.itoosoft.com/index.php?topic=3345.0)" tightly related thread.

Using the Adaptive mode and wiring an empty Segment into the Corner slot will "break" the Array on any vertex, which should help for such scenario.

Hope you'll find it useful.

Best regards,
Title: Re: align joints
Post by: lebonmarie on March 11, 2016, 04:55:09 PM
Thanks to much !!!!!!  ;D