Itoo Software Forum
RailClone => RailClone Pro (*) => Topic started by: GO6827 on October 07, 2022, 12:03:33 PM
-
Hi,
Using a A2S and multiple sub-splines with extend to size, i cannot get the same alignment across the entire RC object. Can it be done without moving the sub-splines?
Thanks!
(https://i.imgur.com/l4t2hry.png)
-
Hi,
If you need a precise placement I find it easier not to use the Extend X/Y Size to area option. Instead, you can manually position it where you need it and then apply the clipping operation separately. Here's how to adapt the scene:
- Turn off Properties > General > Clipping Area > Extend X/Y Size to Area
- Enter a value in Properties > Geometry X Size and Y Size to create an array large enough to cover the area.
- Move the entire RC object over the clipping spline so that it's positioned as you would like.
- Open the Base Objects roll-out and reselect the clipping spline from the scene to update the clipping operation
That should help.
Best regards,
-
Offcourse, thanks alot Michal, works like a charm :)
-
You're welcome. I'm glad to hear, that it helped ;)
Best regards,