Itoo Software Forum

Author Topic: Am I missing something  (Read 4253 times)

bmlokesh

  • Newbie
  • *
  • Posts: 13
Am I missing something
« on: October 25, 2017, 02:21:33 PM »
I am stuck on the glass partition wall system

Instead of creating partition walls with glass, doors and other technical details, thought do it with RC
I am now stuck on glass and the joint, if the silica joint detail is enabled glass is not showing up

am I missing out something please guide me

Paul Roberts

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2991
Re: Am I missing something
« Reply #1 on: October 25, 2017, 03:11:54 PM »
Hi.

Thanks for contacting us. Please see the attached file for a possible solution. I made the following changes.

- Rotated the segments so that they are aligned to the X/Y plane and reset the xforms. I find it's much easier to work this way than rotate the objects in the segment node.
- Remove the end caps from the vertical segments and placed them in the corner inputs
- Disable X Evenly > Extend to sides. This will allow the top and bottom rails to continue the full length of the spline without being broken up by the silicon seals.
- Changed Default mode to Scale.

I hope that helps, please let me know if you have any further questions.

Many Thanks,

Paul
Paul Roberts
iToo Software