Itoo Software Forum
RailClone => RailClone Pro (*) => Topic started by: VelvetElvis on July 20, 2020, 11:53:52 PM
-
I'm hitting an issue when putting seats in an arena and coming to a very short spline segment before the steps. As you can see, there is some odd scaling going on. I either get a mega wide seat or I get teeny little pizza slivers of seats. It is only in these conditions where there isn't enough room for a whole seat before the step. Everywhere else in the arena, the rail clone works perfectly.
Anyone have any tips? I've tried conditional but that still leaves a largely over scaled seat in certain points. Is it more of I just need to adjust the spline itself when this condition presents itself?
I've included the max 2020 file.
-
Hi, please take a look at the attached file which uses conditional operators and an expression to ensure that chairs disappear when the final section is below a certain size and stops scaling until the spline is at least wide enough for two seats. I hope it helps.
(https://i.imgur.com/oDRBmWz.gif)
All the best,
Paul
-
This works perfectly! Once again the support on this forum superb. Thanks for your help!
-
Glad we could help out!