Itoo Software Forum

RailClone => RailClone Pro (*) => Topic started by: VanWijnen on October 15, 2019, 03:58:01 PM

Title: Array on a curved surface
Post by: VanWijnen on October 15, 2019, 03:58:01 PM
Hi,

I've created a RC object that turns a simple rectangle into a brick street. I can't seem to figure out how to use this RC object on the same surface / spline with a slight curve in it. The Linear1S part works just fine but the Array2S not so much. Could you please point out what I'm doing wrong? I've looked at a lot of tutorials and other threads but I couldn't deduce the answer there.
Title: Re: Array on a curved surface
Post by: Dragan on October 15, 2019, 04:21:34 PM
Hi
Try to make the surface slightly larger than the clipping spline.
Title: Re: Array on a curved surface
Post by: VanWijnen on October 16, 2019, 07:22:28 AM
Hi Dragan,

Thanks for the tip! This does bring me closer but it messes the edges up a bit. Any clue on how to fix that?

(Also, apparently the surface has to be in the same postition as the spline to get the right curve)
Title: Re: Array on a curved surface
Post by: Michal KarmazĂ­n on October 16, 2019, 08:11:20 AM
Hi,

Raising the Clipping Area > Expand value should fix it.

Best regards,
Title: Re: Array on a curved surface
Post by: VanWijnen on October 16, 2019, 08:33:38 AM
That fixed it Michal, thanks!