Itoo Software Forum
RailClone => RailClone Pro (*) => Topic started by: RB2300 on May 13, 2021, 03:35:39 PM
-
Hi ... i created full one spline from start and end and set Y OFFSET and then railclone cut half of the way where is crossection and didnt properly follow all way...
if you remove offset then is fully follow... it is just when you set offset..
here is scene and pic best regards P.
-
Hi, please try with this option:
(https://i.imgur.com/7q7DoiQ.png)
Does that do what You want?
-
thank you so much, i didnt know about this checkbox.. Maybe we should remove bug.. in title... Thank you so much