Cladding system

[Darwin Ceballos]

Hi.

Need some advice for creating a cladding system with 3 different planks arranged in example file attached.

Tnx.

[Dragan]

This will be a simple sequence with a Null segment as a sequence terminator. What is your final goal?

[Darwin Ceballos]

Hi, tnx for the tip, end goal is to have different plank lenght on each row, like start with half plank and continue with full, hope it make sense

[Dragan]

Then this could be easy. Just depends on what type of generator you are going for.

[Darwin Ceballos]

Is it possible to use a clipping area ?

Then this could be easy. Just depends on what type of generator you are going for.

[Dragan]

Sure, only "issue" if your clipping spline height is larger than your Sequence it will repeat part of the sequence.

[Darwin Ceballos]

A repeat is ok, but when I'm trying to rotate the cladding (vertical position) I mess it up, where can i control that?

Sure, only "issue" if your clipping spline height is larger than your Sequence it will repeat part of the sequence.

[Dragan]

There is a  Z rotation in Generator's general tab. (Dont have Max right now to make a printscreen)

[Darwin Ceballos]

That did the trick, thank you for helping, will play around with this setup.

There is a  Z rotation in Generator's general tab. (Dont have Max right now to make a printscreen)

[Dragan]

I have exposed some parameters for you. 
- Bond1/Bond2/Rnd1/Rnd2...
  1=Running Bond, 2=Running Bond flipped start, 3=Random stack with full-sized planks, 4=Random stack with random size planks, 5=no stack

- Override X size will override the initial X size for all planks (Useful to set the overall size for no stacked cladding)

- Rnd X/Y/Z Rotation will add some randomization/noise rotation on every single plank

[Darwin Ceballos]

Thanks again Dragan