Itoo Software Forum

Author Topic: cannot see properties  (Read 4272 times)

OB

  • Newbie
  • *
  • Posts: 38
cannot see properties
« on: September 05, 2014, 10:14:54 PM »
Hello !
I recently purchased RailClone PRO , and started to use it, though i encountered a problem - i do not see any properties of nodes. I checked about tab and looks like software is activated. The problem is with activation ?
Thanks.

iToo

  • Administrator
  • Hero Member
  • *****
  • Posts: 4388
    • iToo Software
Re: cannot see properties
« Reply #1 on: September 06, 2014, 09:19:23 AM »
Yes, according to our logs your license has not been activated yet. I will send you details by e-mail.
Carlos Quintero
iToo Software

OB

  • Newbie
  • *
  • Posts: 38
Re: cannot see properties
« Reply #2 on: September 06, 2014, 09:58:40 AM »
Works like a charm , thanks a lot !
I think maybe you could consider fixing this , as when i was installing - there was no questions about activation and license manager was proposed to be installed only if you have floating license or network license. Looks like it should be installed anyway.
Thanks !

iToo

  • Administrator
  • Hero Member
  • *****
  • Posts: 4388
    • iToo Software
Re: cannot see properties
« Reply #3 on: September 06, 2014, 10:38:34 AM »
License Manager is installed always, both in Stand-alone and Network modes. You can see it in the Start Menu.
In this case,  the setup program didn't ask you the license code because there was a license installed. The software has not way to know if it's legitimate or not.
Carlos Quintero
iToo Software