Itoo Software Forum

Author Topic: Cladding direction.  (Read 890 times)

LM1206

  • Newbie
  • *
  • Posts: 34
Cladding direction.
« on: May 22, 2019, 10:16:28 PM »
When I attache splines, some of the cladding goes x-y, some of the cladding goes perpendicularly. How do I fix this? I can't check "vertical" as this reverses all the cladding directions.

Michal Karmazín

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2447
Re: Cladding direction.
« Reply #1 on: May 23, 2019, 02:28:05 PM »
Hi,

In the "to Spline" mode is the X-axis aligned with first Spline's segment and you can use the "Make first" and "Reverse" operations to modify easily the alignment as desired. Hope that helps.

Best regards,