Itoo Software Forum
RailClone => RailClone Pro (*) => Topic started by: LM1206 on May 22, 2019, 10:16:28 PM
-
When I attache splines, some of the cladding goes x-y, some of the cladding goes perpendicularly. How do I fix this? I can't check "vertical" as this reverses all the cladding directions.
-
Hi,
In the "to Spline" mode is the X-axis aligned with first Spline's segment and you can use the "Make first" and "Reverse" operations to modify easily the alignment as desired. Hope that helps.
Best regards,