Itoo Software Forum
RailClone => RailClone Pro (*) => Topic started by: Darwin Ceballos on May 12, 2021, 06:22:57 PM
-
Hi.
Need some advice for creating a cladding system with 3 different planks arranged in example file attached.
Tnx.
-
This will be a simple sequence with a Null segment as a sequence terminator. What is your final goal?
-
Hi, tnx for the tip, end goal is to have different plank lenght on each row, like start with half plank and continue with full, hope it make sense :)
-
Then this could be easy. Just depends on what type of generator you are going for.
-
Is it possible to use a clipping area ?
Then this could be easy. Just depends on what type of generator you are going for.
-
Sure, only "issue" if your clipping spline height is larger than your Sequence it will repeat part of the sequence.
-
A repeat is ok, but when I'm trying to rotate the cladding (vertical position) I mess it up, where can i control that?
Sure, only "issue" if your clipping spline height is larger than your Sequence it will repeat part of the sequence.
-
There is a Z rotation in Generator's general tab. (Dont have Max right now to make a printscreen)
-
That did the trick, thank you for helping, will play around with this setup.
There is a Z rotation in Generator's general tab. (Dont have Max right now to make a printscreen)
-
I have exposed some parameters for you. ;)
- Bond1/Bond2/Rnd1/Rnd2...
1=Running Bond, 2=Running Bond flipped start, 3=Random stack with full-sized planks, 4=Random stack with random size planks, 5=no stack
- Override X size will override the initial X size for all planks (Useful to set the overall size for no stacked cladding)
- Rnd X/Y/Z Rotation will add some randomization/noise rotation on every single plank
-
Thanks again Dragan :) :) :)