Itoo Software Forum

Author Topic: Not follow fully spline  (Read 448 times)

RB2300

  • Newbie
  • *
  • Posts: 47
    • DEVconstruction
Not follow fully spline
« on: May 13, 2021, 03:35:39 PM »
Hi ... i created full one spline from start and end and set Y OFFSET and then railclone cut half of the way where is crossection and didnt properly follow all way...



if you remove offset then is fully follow... it is just when you set offset..

here is scene and pic best regards P.
« Last Edit: May 13, 2021, 03:51:30 PM by Rokas »

Rokas

  • Hero Member
  • *****
  • Posts: 3324
Re: bug - not follow fully spline
« Reply #1 on: May 13, 2021, 03:40:14 PM »
Hi, please try with this option:


Does that do what You want?
Rokas

RB2300

  • Newbie
  • *
  • Posts: 47
    • DEVconstruction
Re: bug - not follow fully spline
« Reply #2 on: May 13, 2021, 03:50:27 PM »
thank you so much, i didnt know about this checkbox.. Maybe we should remove bug.. in title... Thank you so much