Itoo Software Forum

Author Topic: Cladding Wall  (Read 5830 times)

KN4841

  • Newbie
  • *
  • Posts: 3
Cladding Wall
« on: December 12, 2013, 12:19:01 PM »
Hello

I tried to create a Cladding wall with a vertical spline but i have only a good result with an horizontal spline. What is the solution for that problem ?

Thanks

Eric.

iToo

  • Administrator
  • Hero Member
  • *****
  • Posts: 4388
    • iToo Software
Re: Cladding Wall
« Reply #1 on: December 12, 2013, 12:59:59 PM »
By default, regions are applied along the Z local axis of the RailClone object. So, if for example you create the spline in front view, RailClone also must be aligned on this view, so both share the same Z axis.

To avoid messing with local axies, i suggest to create RC and the spline in the top view, then select and rotate both to their final position.
Carlos Quintero
iToo Software

KN4841

  • Newbie
  • *
  • Posts: 3
Re: Cladding Wall
« Reply #2 on: December 12, 2013, 05:13:50 PM »
Thanks for the answer. It work well.