Itoo Software Forum
RailClone => RailClone Pro (*) => Topic started by: KN4841 on December 12, 2013, 12:19:01 PM
-
Hello
I tried to create a Cladding wall with a vertical spline but i have only a good result with an horizontal spline. What is the solution for that problem ?
Thanks
Eric.
-
By default, regions are applied along the Z local axis of the RailClone object. So, if for example you create the spline in front view, RailClone also must be aligned on this view, so both share the same Z axis.
To avoid messing with local axies, i suggest to create RC and the spline in the top view, then select and rotate both to their final position.
-
Thanks for the answer. It work well.