Itoo Software Forum
RailClone => RailClone Pro (*) => Topic started by: Serj Cataev on September 04, 2016, 04:33:33 PM
-
Hello. I'm trying to make a railclone object that creates decorative wall frame. I've attached images where the problem is shown. Also there is a file. I used Linear 1s generator - corner elements are getting messed up. Any suggestions how to get the desired result?
(https://s11.postimg.org/djnjafltr/question.jpg) (https://postimg.org/image/djnjafltr/)
(https://s11.postimg.org/7wr6cyjb3/question2.jpg) (https://postimg.org/image/7wr6cyjb3/)
Regards.
-
Hi,
As the corner Segment isn't symmetrical and needs to be mirrored, I would suggest you to pick the "corresponding one" by the Selector Operator (http://docs.itoosoft.com/display/RAILCLONE/Operators#Operators-Selector) in the Spline Mat ID mode. In attached possible solution vertical lines have the ID 1 assigned and horizontal lines ID 2.
Segments in attached style are using the Pivot Alignment and the precise placement is handled by using an empty Segment with Left & Right Padding values corresponding to corner Segment measurements.
Hope you'll find it useful.
Best regards,
-
Hello Michal, sorry to hijack this post but how do you get this window in you first capture with the dimensions, etc. ?
-
Hi,
No worries at all, it's the 3ds max's Measure (http://help.autodesk.com/view/3DSMAX/2017/ENU/?guid=GUID-12CDEA7A-042E-4CB3-9BF6-8191D3290CD8) utility (Utilities - Measure - New Floater).
Best regadrs,
-
Thank you for resolving my problem. :)